IBM ServeRAID M5025, Руководство пользователя

Страница: 35 / 86

Detailed Installation 2-3
items are missing, contact your place of purchase. The
controller is shipped with the following items:
– A CD containing an electronic version of this
User’s Guide , and related documentation
– Warranty information
Step 2. Turn off the Power to the System
Review all safety information provided with the computer; then,
turn off the power to the computer, unplug the power cords
from the power supplies, disconnect the computer from the
network, and remove the computer cover. See the
documentation provided with the computer for instructions.
Before you install the controller, make sure that the computer
is disconnected from the power and from any networks.
Step 3. Review the ServeRAID M5025 Controller Connectors
Refer to Chapter 3, “ServeRAID M5025 SAS/SATA Controller
Characteristics” for a diagram of the ServeRAID M5025
controller with its connectors.
Step 4. Review the Controller Limitations
Review Section 1.2.1, “Controller Limitations” before you install
the controller in the system.
Step 5. Check the Intelligent Battery Backup Unit
Make sure that the iBBU is present.
Step 6. Install the ServeRAID M5025 Controller
Select a PCI Express slot and align the controller’s PCI
Express bus connector to the slot. Press down gently but firmly
to ensure that the card is properly seated in the slot. Secure
the bracket to the computer chassis.
Figure 2.1 shows the installation of the ServeRAID M5025
controller in a PCI Express slot.
Note: Some PCI-E slots support PCI-E graphics cards only. If a
RAID controller is installed one of those slots, the controller
will not function.