IBM RackSwitch G8264T, Руководство по установке, Страница: 49 / 64

© Copyright IBM Corp. 2012 Chapter 2. Installing the RackSwitch G8264T
35
Installing or replacing a fan module
The RackSwitch G8264T contains four hot-swap fan modules. All four fan modules
are required for normal operation.
The switch continues to operate when there is one failed fan module. If one fan
module fails, the switch sends an error message. If a second module fails, the
switch sends an error message, writes a failure log to flash memory, and shuts
down.
Each fan module has a green LED that is visible from rear panel. The LED shows
the status of the fan module, as follows:
•
LED is lit: Fans are operational.
• LED is off: Switch unit has no power.
• LED flashes: Fan speed has failed. Replace the fan module.
Removing a fan module
To remove a fan module, perform the following steps:
1. Loosen the retainer screw.
2. Grasp the extractor handle and gently pull the fan module from the slot.
Attention: Replace the fan module within 5 minutes to avoid overheating the
switch.
Installing a fan module
To install a fan module, perform the following steps:
1. Remove the fan module from the anti-static shielded bag.
2. Slide the fan module into the card guides in the open slot and gently push it all
the way into the slot, so that it firmly engages with the connector see the
illustration). Each fan module has a mechanical guide key to prevent you from
inserting the module incorrectly.
3. Tighten the retaining screw on the fan module. Torque the screw to
approximately 4 inch-pounds (0.5 Nm).