IBM PS700, Инструкция по установке и эксплуатации

Страница: 57 / 74

Chapter 5. Installing the operating system
Before you install the operating system on the blade server, verify that the blade server is installed in the
BladeCenter unit, the management-module firmware is at the latest available level, and the blade server
is turned on.
If you are not using an unattended network-installation method to install your operating system, you
must first provide a Serial over LAN (SOL) connection to the blade server to install your operating
system. If you have not already done so, configure the SOL feature on the blade server to establish an
SOL connection, enable the SOL feature, and start an SOL session. For instructions, see the
IBM
BladeCenter Serial over LAN Setup Guide and the BladeCenter Management Module Command-Line Interface
Reference Guide . For information about SOL commands, see the documentation for your operating system.
Important:
v
If you plan to install the operating system through the Ethernet network, you must install and
configure a second Ethernet switch module into the applicable I/O-module bay of the BladeCenter
unit. For additional information, see:
– “Configuring the Gigabit Ethernet controllers” on page 40
– “Blade server Ethernet controller enumeration” on page 41
– The documentation that comes with the Ethernet switch module that you are using
v
After you install the operating system on the blade server, you must install any service packs or
update packages that come with the operating system. For additional information, see the instructions
that come with your operating-system documentation and the service packs or update packages.
v
The blade server has no external USB ports, but communicates with and uses the removable-media
drives and USB ports that are in the media tray of the BladeCenter unit.
v
The operating system in the blade server must provide USB support for the blade server to recognize
and use the removable-media drives in the BladeCenter unit. The BladeCenter unit uses USB for
internal communication with these devices.
v For the BladeCenter PS700 blade server, if you plan to install an Ethernet expansion card, first install
the operating system to enable the onboard ports to be recognized and configured before the ports on
the expansion card. If you install the Ethernet expansion card
before you install the operating system,
the expansion card ports will be assigned before the onboard ports.
See the ServerProven Web site for information about supported operating-system versions and all PS700
blade server optional devices.
© Copyright IBM Corp. 2010, 2011
45