IBM PCI Cryptographic Coprocessor, Инструкция по установке и использованию

Страница: 26 / 34

Attention: Any loss of power erases data stored in the card’s protected memory.
To prevent loss, ensure that the battery tray contains a fresh battery
and is attached to the J3 connector.
7. Replace the batteries in positions BT1, BT3, and BT4. To eject a battery, turn the
coprocessor over and insert a small object, such as a screwdriver, through the
hole to eject the battery.
8. Replace the battery in the BT2 position with the battery in the battery tray. (The
new batteries provide power to the coprocessor while you perform this step.)
9. Remove the battery tray from the J3 connector, and discard it.
10. Reinstall the coprocessor into the PCI bus slot; be sure the card is fully seated.
11. Replace the host computer’s cover.
12. Reconnect the power cable and any other cables that you disconnected.
13. Turn the computer on. The coprocessor runs its power-on self-test.
14. The batteries are lithium 3-volt batteries. Recycle or dispose of the old batteries as
required by local law.
You have completed the procedure for replacing the coprocessor batteries.
BT2 BT3
BT1 BT4
J3
J6
J2
+
+
+
+
18
PCI Cryptographic Coprocessor Installation and Using Guide