IBM PC 300PL, Установка

Страница: 95 / 112

To access the Configuration/Setup Utility program:
1
Turn on the computer.
If your computer is on when you start this procedure, you must shut down
the operating system, turn off the computer and wait a few seconds, and then
restart the computer. Do not use Ctrl+Alt+Del to restart the computer.
2
When the Configuration/Setup Utility prompt appears in the lower left corner
of the screen, press F1.
a. If you have not set an administrator password, the Configuration/Setup
Utility program menu appears. If you have set an administrator
password, type the administrator password and press Enter.
b. If you have set both an administrator and a power-on password, you can
type either of the passwords at the password prompt. However, if you
type your power-on password, you can view limited information in the
Configuration/Setup Utility program, but you cannot change settings. To
change settings in the Configuration/Setup Utility program, type your
administrator password at the password prompt.
Note: The menu you see on your computer might look slightly different from the
menu shown here, but it will operate the same way.
Configuration/Setup Utility
Select Option:
Ÿ
System Summary
Ÿ
Product Data
Ÿ
Devices and I/O Ports
Ÿ
Start Options
Ÿ
Date and Time
Ÿ
System Security
Ÿ
Advanced Setup
Ÿ
ISA Legacy Resources
Ÿ
Power Management
Save Settings
Restore Settings
Load Default Settings
Exit Setup
Chapter 7. Completing the Installation
81
All manuals and user guides at all-guides.com