IBM PC 300GL Type 6591, Руководство по установке

Страница: 51 / 108

Style 2
1
Make sure the system-board latch handle is in the extended position.
2
Align the system-board rails with the tracks on the chassis. Grasp the rails
and slide the board in until it is approximately 6 mm. (0.25 in.) from the riser
card edge connector.
3
Rotate the latch handle counter-clockwise until the system board is properly
aligned with the riser card edge connector. Continue rotating the latch handle
counter clockwise while firmly pushing on the end of the right-hand rail.
When the system board is fully seated the tab on the right-hand rail is
engaged in an opening in the chassis.
CAUTION:
Do not push on the microprocessor, memory modules, memory sockets, or
other system-board components to install the system board.
4
Push down on the latch handle to engage the tab on the under side into the
opening in the chassis. This holds the latch in the latched position.
Tab
Push
Here
System Board
Tab
Hole
Note:
You cannot see the connection with a full-sized adapter in place. To
make sure the system board is fully seated, it is important that the tab
on the right-hand rail is engaged in the opening in the chassis.
Chapter 4. Working with Adapters
37