5. Determine if you have a 3.5-inch bay or a 5.25-inch bay for
installation. If you have a 5.25-inch bay available, use the tape
drive as it is, or you can use the black 5.25-inch bezel which is
included in your option package. If you only have a 3.5-inch bay
available, remove the side rails on the tape drive and replace the
5.25- bezel with either of the included 3.5-inch bezels, as
illustrated in the following picture.
6. Mount the tape drive in either a horizontal or vertical position.
The drive has two sets of mounting holes to allow for a number
Pins 5-6
Pins 3-4
Pins 1-2
SCSI ID
of mounting positions. There are two holes
.1/ .2/
in each set;
use only one set of mounting holes. The following illustration
shows the mounting holes on only one side of the drive.
Insert each of the screws through a drive-bay mounting hole into
a threaded screw hole on the tape drive; then tighten with a
screwdriver.
7. To install the cables, refer to the following illustration:
Off
Off
Off
0
Off
Off
On
1
Off
On
Off
2
Off
On
On
3
On
Off
Off
4
On
Off
On
5
On
On
Off
6
On
On
On
7
Part 1: Quick Installation Guide
1-3
All manuals and user guides at all-guides.com
