IBM Netfinity 1000-8477 21Y, Руководство по техническому обслуживанию аппаратной части

Страница: 31 / 268

Utility program (see “SCSISelect utility program” on
page 50). Review the information that comes with the
option before making changes.
When you restart the server for the first time after working
with most options, a message appears, indicating that a
configuration change has occurred. You are then
prompted to enter the Configuration/Setup Utility program
to manually update the configuration settings or to confirm
and save the settings that were automatically updated by
the system programs.
After you change an option and restart the server, the
following screen might appear.
POST Startup Error(s)
The following error(s) were detected when the system was
started:
162 Configuration Change Has Occurred
Select one of the following:
Continue
Exit Setup
Note
Depending on the configuration changes that
occurred, the error message that you see might be
different from the one shown here.
If the preceding screen appears, select Continue until you
reach the Configuration/Setup Utility program menu; then,
go to “Configuration/Setup utility program menus” on
page 25.
If the preceding screen does not appear, use the following
procedures to access the Configuration/Setup Utility
program menu.
To start the Configuration/Setup Utility program:
1. Power-on the server and watch the screen.
If the server is already turned on, power-off the
server, wait a few seconds until all in-use lights go
off, and then power the server back on. (Do not use
Ctrl+Alt+Del to restart the server.)
2. When the message
Press F1 to enter
Configuration/Setup
appears, press F1. The
Configuration/Setup Utility program menu appears.
For information about the menus, see
“Configuration/Setup utility program menus” on
page 25.
IBM Netfinity 1000 - Type 8477
23