IBM Netfinity 1000-8477 21Y, Руководство по техническому обслуживанию аппаратной части

Страница: 115 / 268

Before you can install drives in the Netfinity 1000 server,
you might need to perform certain preinstallation activities.
Some of the steps are required only during the initial
installation of an option.
1. Remove the server side cover (see “Disconnecting
cables and removing the side cover” on page 85).
2. Choose the bay in which you want to install the drive.
(Refer to Table 4 on page 100 for the drive types
and sizes available for each bay.)
3. Access the appropriate drive bays.
Notes
1. In all models, drive bays 1 and 4 come with
drives preinstalled.
2. In some models, drive bay 6 comes with a
drive preinstalled.
3. Drive bays 2 and 3 have a bay panel (bezel)
and static shield installed.
4. If you remove a drive that has removable
media and you do not intend to install a new
drive immediately, reinstall the static shield
and bay panel for that bay.
To access drive bays 1 through 4, go to “Working
with drives in bays 1 through 4” on page 108.
To access drive bays 5 and 6, go to “Working with
drives in bays 5 and 6” on page 120.
4. Touch the static-protective bag containing the drive to
any unpainted metal surface on the server; then,
remove the drive from the bag.
5. Check the instructions that come with the drive, or
contact your IBM reseller or IBM marketing
representative to see if you need to set any switches
or jumpers on the drive, or if you need to attach a
tray to the drive.
IBM Netfinity 1000 - Type 8477
107