IBM LS21 - BladeCenter - 7971, Инструкция по установке и эксплуатации

Страница: 34 / 84

Removing the bezel assembly
To install certain options, you must first remove the bezel assembly. The following
illustration shows how to remove the blade server bezel assembly. The illustration
and instructions also apply to the MPE bezel assembly, except that the MPE does
not have a control-panel connector.
Bezel-assembly
release (both sides)
Bezel assembly
Control-panel
connector
Control-panel
cable
To remove the blade server bezel assembly, complete the following steps:
1. Read the safety information beginning on page v and “Installation guidelines” on
page 17.
2. Open the blade server cover (see “Opening the blade server cover” on page 20
for instructions).
3. If you are removing the bezel assembly from the blade server and an expansion
unit is connected to the blade server, remove the expansion unit (see
“Removing an expansion unit” on page 21).
4. Press the bezel-assembly release and pull the bezel assembly away from the
blade server approximately 1.2 cm (0.5 inch).
5. If you are removing the bezel assembly from the blade server, disconnect the
control-panel cable from the control-panel connector.
6. Pull the bezel assembly away from the blade server.
7. Store the bezel assembly in a safe place.
22
BladeCenter LS21 Type 7971 and LS41 Type 7972: Installation and User’s Guide