IBM IntelliStation Z Pro 6223, Руководство пользователя

Страница: 59 / 134

v
Two Serial ATA hard disk drive connectors are on the system board.
v If you install SCSI hard disk drives and SATA hard disk drives in the same
computer, note the following HostRAID considerations for hard disk drives:
– You can enable HostRAID on only one subsystem (SCSI or SATA).
– If HostRAID is enabled on a subsystem, you can install boot hard disk drives
on that subsystem only.
If you fail to observe these restrictions, the computer will usually disable the
BIOS for the last subsystem loaded, which typically is SCSI.
For more information about HostRAID, see “Using the Adaptec HostRAID
configuration programs” on page 26.
v The electromagnetic interference (EMI) integrity and cooling of the computer are
protected by having all bays, PCI, and PCI-X slots covered or occupied. When
you install a drive, PCI adapter, or PCI-X adapter, save the EMC shield and filler
panel from the bay or the adapter slot cover in the event you later remove the
drive or adapter.
v
For a complete list of supported options for your computer, go to
http://www.ibm.com/pc/; then, select your country and navigate to the list of
options for your computer.
Installing a drive in bay 2 or 3
Complete the following steps to install a drive in bay 2 or 3:
1. Read the safety information beginning on page vii and “Installation guidelines”
on page 33.
2. Turn off the computer and peripheral devices, and disconnect the power cords
and all external cables.
3. Remove the side cover (see “Removing the side cover” on page 38).
4. Remove the bezel (see “Removing the bezel” on page 39).
Chapter 4. Installing options
45