IBM HS22V BLADECENTER - X5670 FOR SPEC CPU2006, Спецификация

Страница: 46 / 80

46
•
To create an IBM i partition, click View/Modify Partitions
•
Click Create Partition . Partition ID will default to the next available partition number
•
Enter a name for the partition
•
Select Environment: IBM i
•
Click Next
•
Set the assigned (desired) memory value
•
Click Next
•
Set the desired processor configuration
•
Click Next
•
Set the first Virtual Ethernet adapter to VLAN1, which you previously configured for
bridging
•
Click Next
•
Select Assign existing virtual disks and physical volumes
•
Click Next
•
Choose the LUNs or SAS disks you configured for IBM i from the list of Available
Physical Volumes. If you are using a BladeCenter S and need to configure IBM i
disk mirroring after installation, see also section 5.13
•
Click Next
•
Select the USB physical optical drive in the top portion of the screen to virtualize the
DVD-ROM drive in the BladeCenter to IBM i (this assumes the media tray is assigned
to this blade)
•
Click Next . Review the summary
•
Click Finish .
5.11. Create the LAN console connection on the console PC
Following section 1.5 of this document, you should have System i Access installed on a PC that is
on the same subnet as the IP address you are going to assign to the new IBM i partition for LAN
console. To configure the Operations Console (LAN) connection, follow the process described in
this section of the IBM i Information Center:
http://publib.boulder.ibm.com/infocenter/systems/scope/i5os/index.jsp?topic=/rzajr/rzajrcfglancon
sole.htm. Keep in mind the following tips:
•
IBM i partitions on Power blade have partition IDs of 2 or higher (VIOS always has
partition ID 1)
•
You can look up the serial number of the blade in IVM by clicking on View/Modify
System Properties .
Note that the LAN console uses an IP address separate from the ones for VIOS and, later, the
IBM i LPAR production interface. See section 1.4 for a full list of the IP addresses required for
implementing IBM i on blade. Once the LAN console connection is configured, start it in
preparation for installing IBM i.
5.12. Install IBM i
Once the prerequisites for installation above have been completed, installing IBM i on Power
blade is essentially the same as on any other supported system.
•
Place the IBM i installation media in the DVD-ROM drive in the BladeCenter (which at
this point should be assigned to your blade and selected in the IBM i partition’s
properties)
•
In IVM, click on View/Modify Partitions