IBM HC10 - BladeCenter - 7996, Руководство по обслуживанию

Страница: 67 / 114

v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v
See Chapter 3, “Parts listing, Type 7996,” on page 11 to determine which components are CRUs and which
components are FRUs.
v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a
trained service technician.
Error code Description Action
I9990305 Operating system not found
1. Run the Configuration/Setup Utility program,
select Startup Options . Configure the hard disk
drive to be the primary startup device and save
the settings.
2. Make sure that a bootable operating system is
installed on the hard disk drive.
3. Reseat the hard disk drive.
4. Replace the following components one at a time,
in the order shown, restarting the blade
workstation each time:
a. Hard disk drive
b. (Trained service technician only) System
board assembly
Error logs
The BMC log contains all system status messages from the blade workstation
service processor. The management-module event log in your BladeCenter unit
contains messages that were generated on each blade workstation during POST
and status messages from the BladeCenter service processor. (See the
Management Module User’s Guide for more information.)
The following illustration shows an example of a BMC log entry.
BMC System Event Log
----------------------------------------------------------
Get Next Entry
Get Previous Entry
Clear BMC SEL
Entry Number= 00005 / 00011
Record ID= 0005
Record Type= 02
Timestamp= 2005/01/25 16:15:17
Entry Details: Generator ID= 0020
Sensor Type= 04
Assertion Event
Fan
Threshold
Lower Non-critical - going high
Sensor Number= 40
Event Direction/Type= 01
Event Data= 52 00 1A
Important:
v
A single problem might cause several error messages. When this
occurs, work to correct the cause of the first error message. After
Chapter 5. Diagnostics
51