IBM HC10 - BladeCenter - 7996, Руководство по обслуживанию

Страница: 62 / 114

v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v
See Chapter 3, “Parts listing, Type 7996,” on page 11 to determine which components are CRUs and which
components are FRUs.
v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a
trained service technician.
Error code Description Action
602 Invalid diskette boot record.
1. Check the function of the shared BladeCenter unit
resources (see “Solving shared BladeCenter
resource problems” on page 75).
2. Make sure the diskette works with another blade
workstation.
3. (Trained service technician only) Replace the
system board assembly
1162 Configuration change has occurred.
1. Run the Configuration/Setup Utility program and
change the resources assigned to the serial port.
2. Check the function of the shared BladeCenter unit
resources (see “Solving shared BladeCenter
resource problems” on page 75).
3. (Trained service technician only) Replace the
system board assembly
1600 BMC failure. Shutdown and remove the blade workstation from the
BladeCenter unit, wait 30 seconds; then, reinstall the
blade workstation in the BladeCenter unit and restart
it. If the problem persists, perform the following tasks
in the order shown, restarting the blade workstation
each time:
1. Update the BMC firmware.
2. (Trained service technician only) Replace the
system board assembly.
1601 BMC is not responding. Shutdown and remove the blade workstation from the
BladeCenter unit, wait 30 seconds; then, reinstall the
blade workstation in the BladeCenter unit and restart
it. If the problem persists, perform the following tasks
in the order shown, restarting the blade workstation
each time:
1. Update the BMC firmware.
2. (Trained service technician only) Replace the
system board assembly.
1762 Hard disk configuration changed
1. Run the Configuration/Setup Utility program,
make sure that the hard disk drive configuration is
correct, and save the settings.
2. Reseat the hard disk drive.
3. Replace the following components one at a time,
in the order shown, restarting the blade
workstation each time:
a. Hard disk drive
b. (Trained service technician only) System
board assembly
46
BladeCenter HC10 Type 7996: Problem Determination and Service Guide