IBM HC10 - BladeCenter - 7996, Руководство по обслуживанию

Страница: 53 / 114

Installing the system board assembly
To install the system board assembly, complete the following steps:
1. Install all of the components in the following list that were removed from the old
system board assembly onto the new system board assembly.
v
Microprocessor and heat sink. See “Installing a microprocessor and heat
sink” on page 34.
v
Hard disk drive. See “Installing a SATA storage drive” on page 23.
v DIMMs. See “Installing a memory module” on page 24.
v
Graphics card. See “Installing a graphics card” on page 29.
v Compression card. See “Installing a compression card” on page 27.
2. Install the bezel assembly (see “Installing the bezel assembly” on page 21).
3. Install the blade workstation cover (see “Installing the blade workstation cover”
on page 20).
4. Install the blade workstation into the BladeCenter unit (see “Installing the blade
workstation in a BladeCenter unit” on page 17).
Chapter 4. Removing and replacing blade workstation components
37