IBM EXP15, Руководство по техническому обслуживанию аппаратной части

Страница: 50 / 146

b. If the Fault light is solid amber, pull up on the
drive latch and lift the drive lever to pull the drive
partially out of the bay. Wait at least 20 seconds
before fully removing the drive from the
expansion unit to allow for spin down. If the
SCSI adapter is the IBM ServeRAID II; go to the
ServeRAID User's Guide for additional
information and procedures on changing the
state of the drive from the current Default state
to any other state (for example, HSP, RDY,
rebuild drive to ONL, and so on). The amber
LED should go off within 10 seconds of the drive
state change (to something other than DDD).
If the SCSI adapter is the IBM ServeRAID II, in
some cases, the drive will automatically reset to
either a hotspare (HSP) or be rebuilt (ONL).
See the ServeRAID II User's Guide for additional
information. If the state change in the
ServeRAID II configuration does not change
automatically (amber LED does not go off), then
refer to the ServeRAID II User's Guide for
directions on how to perform a manual drive
state change. The amber LED should go off
within 10 seconds of a drive state change (to
something other than DDD).
If the state change in the RAID configuration
does not change automatically, refer to the
RAID
Controller User's Guide for directions on how to
perform a drive state change.
LED drive status:
The following table shows the LED status on the drives:
LED Description
Activity (green/flashing) Indicates read/write or
inquiry operation
Fault (amber/flashing) Indicates drive rebuild or
that drive has been
identified by software
Fault (amber) Indicates a drive failure
42
IBM Netfinity EXP15, EXP200, EXP500 HMM