IBM EXP15, Руководство по техническому обслуживанию аппаратной части

Страница: 102 / 146

Working with GBICs:
The expansion unit has four
gigabit interface card (GBIC) ports (two on each ESM
board). Use the GBIC ports to attach FC cables to the
expansion unit.
Installing GBICs:
This section provides information on
installing GBICs and adding additional Netfinity Fibre Array
Storage Technology (FAStT) EXP500 expansion units to a
loop. The GBICs are laser products.
Caution
When laser products (such as CD-ROMs, DVD drives,
fiber optic devices, or transmitters) are installed, note
the following:
Do not remove the covers. Removing the covers
of the laser product could result in exposure to
hazardous laser radiation. There are no
serviceable parts inside the device.
Use of controls or adjustments or performance of
procedures other than those specified herein
might result in hazardous radiation exposure.
To install a GBIC, do the following:
Remove the protective cap from the GBIC.
Move the GBIC latch to the unlocked (center)
position.
Insert the GBIC into the GBIC port on the ESM board.
Move the GBIC latch back to the locked position
(flush with the rear of the GBIC).
94
IBM Netfinity EXP15, EXP200, EXP500 HMM