IBM Enterprise Server S80, Руководство пользователя

Страница: 193 / 282

Step 3. Running System Verification
1. On the Diagnostic Operating Instructions Screen, press the Enter key.
2. If the terminal type has not been defined, you must use the
Initialize Terminal
option on the Function Selection menu to initialize the operating system
environment before you can continue with the diagnostics.
3. If you want to do a general checkout with minimal operator action, select the
Diagnostic Routines
option on the Function Selection menu.
If you want to do a more complete checkout including the use of wrap plugs, select
the
Advanced Diagnostics
option on the Function Selection menu. The advanced
diagnostics are primarily for the service representative; they may instruct you to
install wrap plugs to better isolate a problem.
4. Select the
System Verification
option on the Diagnostic Mode Selection menu.
5. If you want to run a general checkout of all installed resources, select the
All
Resource
option on the Diagnostic Selection menu.
If you want to check one particular resource, select that resource on the Diagnostic
Selection menu.
6. Go to “Step 4. Additional System Verification”.
Step 4. Additional System Verification
The checkout programs end with either the Testing Complete menu and a message
stating
No trouble was found
or the A Problem Was Detected On (Time Stamp) menu
with an SRN.
1. Press Enter to return to the Diagnostic Selection menu.
2. If you want to check other resources, select the resource. When you have checked
all of the resources you need to check, go to “Step 5. Stopping the Diagnostics”.
Step 5. Stopping the Diagnostics
1. If you are running Online diagnostics, shut down the system, using the following
procedure:
a. Press the 3 key repeatedly until you get to the Diagnostic Operating Instructions,
then follow the displayed instructions.
b. Press the 3 key once, and then follow the displayed instructions to shut down
the system.
2. If you changed any attributes on your ASCII terminal to run the diagnostics, change
the settings back to normal.
3. This completes the system verification. Report the SRN if you received one to the
service organization. To do a normal boot, turn off the system unit and wait 30
seconds, and then turn the system power on.
Chapter 7. Using the System Verification Procedure
175