IBM DCS3860, Инструкция по установке, использованию и обслуживанию

Страница: 56 / 204

Installing the DCS3860 into the rack cabinet without using a lift tool
Complete the following steps to install the storage enclosure if you do not have a
lift tool:
≥ 18 kg (39.7 lb) ≥ 32 kg (70.5 lb) ≥ 55 kg (121.2 lb)
1. Prepare the storage enclosure for installation:
a.
Remove the foam shipping material from the sides and ends of the storage
enclosure.
b. If necessary, cut away sides of the shipping box to access the storage
enclosure.
c. Open the plastic bag and tuck it under the storage enclosure. The plastic
bag reduces friction and makes it easier to move the unit out of the
shipping box and then into the rack cabinet.
d.
Install the four handles on the sides of the storage enclosure. See “Installing
and removing the handles” on page 35 for detailed instructions.
2. Lift the storage enclosure off the side of the shipping box. Align it in front of
the rack.
3.
Put the rear edge of the storage enclosure on the support rails.
4. Remove the two handles (one on each side) at the rear of the storage enclosure.
Do not remove the front handles on both sides of the unit.
5. Slide the storage enclosure halfway into the rack and remove the two handles
(one on each side) at the front of the unit.
Front
Rear
6.
Install and tighten two M5 screws on each side of the rack, above and below
the top M5 screws, in the front of the storage enclosure to secure the storage
expansion enclosure.
38
IBM System Storage DCS3860 Storage System: Installation, User's, and Maintenance Guide