IBM DCS3860, Инструкция по установке, использованию и обслуживанию

Страница: 106 / 204

8. Press the card in the controller and tighten the three captive fasteners.
9.
Install and secure the cover plate with four screws and then install the cover.
10. Insert the controller into the chassis.
a.
Ensure that the release levers on the controller are in the open position.
b. Slide the controller into the bay until it stops.
c. Push the release lever without the orange attachment to the closed
position. Then, push the release lever with the orange attachment. Ensure
that both the release levers are in the closed position.
Note: If a different HIC is installed or if the HIC is removed, then perform
this step on the other controller too.
11.
Reconnect the cables that you disconnected.
12. If necessary, turn on the storage system (see “Powering on the DCS3860” on
page 56).
13.
Check the WWIDs or the MAC addresses of the host ports after replacing the
controller or the host port interface adapter, or both. If you need to change
any WWID or MAC address, update the servers or switches in the
configuration.
Working with hot-swap DDMs
This section contains information about how you can increase the storage
expansion enclosure capacity by adding more DDMs or by replacing existing
DDMs with ones that have a larger capacity.
Before you begin, complete the following tasks:
dcsi0072
Connector
Figure 43. Aligning the HIC connector
88
IBM System Storage DCS3860 Storage System: Installation, User's, and Maintenance Guide