IBM CP20 - Workstation Connection Device KVM, Руководство по установке

Страница: 21 / 56

17. Turn off and turn on the connection device.
18. On a system (other than the blade server to which you are connecting the
connection device) that is on the same subnet as the compression card, open
a Web browser.
19. Direct the Web browser to the IP address of the compression card. The
compression card Web interface opens.
20. In the compression card Web interface, type your password and click Log In ;
then, click Configuration Session .
21. Clear the Accept Any Peer check box.
22. Type the MAC address of the connection device, and click Apply .
23. Click Configuration ; then, click Monitor Emulation .
Note: When monitor emulation is enabled, KVM access for the host system is
not available.
24. Enable monitor emulation for each DVI connector in use on the connection
device.
25. Click Apply .
26. Click Reset .
27. If the host system is on, shut down the host system.
28. Go to the workstation connection device and click Connect . This will power on
the host system and allow you to see the system as it goes through POST.
Chapter 3. Setting up the connection between the connection device and the host system
11