IBM CP20 - Workstation Connection Device KVM, Руководство по установке

Страница: 20 / 56

18. Click Configuration ; then, click Monitor Emulation .
Note: When monitor emulation is enabled, KVM access for the host system is
not available.
19. Enable monitor emulation for each DVI connector in use on the connection
device.
20. Click Apply .
21. Click Reset .
22. If the host system is on, shut down the host system.
23. Go to the workstation connection device and click Connect . This will power on
the host system and allow you to see the system as it goes through POST.
Setting up the connection using static IP addresses
To set up a remote session using static IP addresses, complete the following steps:
1. Turn on the host system and press F1 to start the Configuration/Setup Utility
program.
Note: Use the keyboard, video, and mouse connected to the management
module in the BladeCenter unit to configure the host system.
2. Select Advanced Setup
→
Compression Card Network Configuration .
3. Change the compression card IP address to static.
4. Type the IP address, subnet mask, and gateway of the compression card.
5. Select Save Network Settings in Compression Card and press Enter . Then,
press Enter again to continue.
6. Note the MAC address and IP address of the compression card.
7. Exit the Configuration/Setup Utility program and save the settings.
8. Press and hold the power-control button on the host system for more than 5
seconds to turn it off.
9. Turn on the connection device. The workstation interface, On Screen Display
(OSD), will load.
10. Go to the workstation connection device; then, click Options , Configuration ,
then Unlock .
11. Type your password. The default password is PASSW0RD, with all uppercase
letters and the numeral zero.
12. Clear the Enable DHCP check box.
13. Type the IP address, subnet mask, and gateway of the connection device.
Important: Make sure that the IP addresses of the compression card on the
host system and the connection device are on the same network.
If they are not, the connection will fail. Use the PING utility on the
workstation connection device to verify that the IP address of the
compression card on the host system is accessible. For more
information, see “Ping tool” on page 15.
14. Type the IP address and MAC address of the compression card, and click
Apply .
15. Click the Discovery tab; then, clear the Enable Host Discovery check box
and click OK .
16. Click Options , then Information . Note the MAC address of the connection
device. The MAC address is also available from a label on the connection
device.
10
IBM CP20 Workstation Connection Device: Installation Instructions