IBM BladeCenter QS20, Инструкция по установке и эксплуатации

Страница: 23 / 92

C hapter 2 . B lade server power , controls , and indicators
This chapter describes the power features, how to turn on and turn off the blade
server, and what the controls and indicators mean.
T urnin g on the blade server
N otes:
v
After you have installed the BladeCenter QS20, wait until the power-on L E D on
the blade server flashes slowly before pressing the blade server power-control
button. Before the L E D flashes, the service processor in the BladeCenter
Management Module is initiali z ing, and the power-control button on the blade
server will not respond.
v
While the blade server is powering up, the power-on L E D on the front of the
server is lit. See “ Blade server controls and L E Ds ” on page 11 for the power-on
L E D states.
v Throughout this document, the Management Module Web-based user interface is
also known as the BladeCenter Management Module Web interface.
After you have installed the BladeCenter QS20, the blade server can start in any of
the following ways:
v
You can press the power-control button on the front of the blade server ( behind
the control-panel door ) to start the server.
v
If a power failure occurs, the BladeCenter unit and then the blade server can
start automatically when power is restored ( if the blade server is configured
through the BladeCenter Management Module to do so ) .
v You can use the BladeCenter Management Module Web interface to turn on the
blade server remotely.
© Copyright IBM Corp. 200 5
9