IBM BladeCenter QS20, Инструкция по установке и эксплуатации

Страница: 55 / 92

1 . Read the safety information beginning on page v and “ Installation guidelines ” on
page 2 1 .
2. Connect the control-panel cable to the control-panel connector on the
system-board assembly.
3 . Connect the serial cable from the serial connector to the serial connector on the
system-board assembly.
4. Carefully slide the be z el assembly onto the blade server as shown in the
illustration, until it clicks into place.
N ote:
v If InfiniBand is installed, partially insert the side fins of the be z el into the
metal guides while ensuring that the top of the be z el rests on the foam
gasket on the InfiniBand card.
v
Make sure the serial cable, routed along the inside and across the bottom
of the be z el, is housed underneath the blade ’ s board.
Chapter 5 . Installing and removing replaceable units
41