IBM BladeCenter HC10 Type 7996, Руководство по обслуживанию

Страница: 41 / 114

To install a DIMM, complete the following steps.
DIMM 2
DIMM 1
DIMM 2 connector
DIMM 4
DIMM 3
DIMM 4 connector
1. Read the documentation that comes with the DIMM.
2. Locate the DIMM connectors.
3. Determine the connectors into which you will install the DIMMs.
4. Touch the static-protective package that contains the DIMM to any unpainted
metal surface on the BladeCenter unit or any unpainted metal surface on any
other grounded rack component; then, remove the DIMM from the package.
Attention: To avoid breaking the DIMM retaining clips or damaging the DIMM
connectors, open and close the clips gently.
DIMM
Retaining clip
5. Make sure that both of the connector retaining clips are in the fully open
position.
6. Turn the DIMM so that the DIMM keys align correctly with the connector on the
system board.
7. Insert the DIMM by pressing the DIMM along the guides into the connector.
Make sure that the retaining clips snap into the closed positions.
Attention: If there is a gap between the DIMM and the retaining clips, the
DIMM has not been correctly installed. In this case, open the retaining clips and
remove the DIMM; then, reinsert the DIMM.
8. Install the blade workstation cover (see “Installing the blade workstation cover”
on page 20).
9. Install the blade workstation into the BladeCenter unit (see “Installing the blade
workstation in a BladeCenter unit” on page 17).
Chapter 4. Removing and replacing blade workstation components
25