IBM ATA 133, Руководство пользователя

Страница: 5 / 54

Preface v
Preface
The IBM PCI Bus Master ATA 133 RAID Disk Array Controller provides a cost-
effective way to achieve higher transfer rates and reliability. IBM’s IDE controller
supports two IDE channels and up to four drives. It supports the following drive modes:
PIO 0-4, DMA 0-2, and Ultra DMA 0-6. The RAID levels supported are RAID 0, 1, and
10. The highest data transfer rate in UDMA mode 4 is 66 MBs, in UDMA mode 5 is 100
MBs, and in UDMA mode 6 is 133 MBs. This manual describes the IBM ATA 133
RAID controller.
Package Contents You should have received the following:
• An IBM ATA 133 RAID controller card
•
Two standard length 40-pin connector ATA-100/133 cables with two drive
connectors
•
Two extended length 40-pin connector ATA-100/133 cables with one drive
connector
•
The IBM ATA 133 RAID Controller Quick Hardware Setup Guide (hard copy)
•
A Driver and Documentation CD with utility programs, device drivers for various
operating systems, and the following documentation:
•
The IBM ATA 133 RAID Controller User's Guide (on CD)
•
A software license agreement
FCC Regulatory Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
specific installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, try to correct the interference by one or more
of the following measures:
1)
Reorient or relocate the receiving antenna.
2) Increase the separation between the equipment and the receiver.
3) Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
4) Consult the dealer or an experienced radio/TV technician for help.
Shielded interface cables must be used with this product to ensure compliance with the Class B FCC
limits.
LSI IDE PCI RAID Disk Array Controller
Model Number: Series 524