IBM ATA 133, Руководство пользователя

Страница: 26 / 54

IBM ATA 133 RAID Controller User's Guide 20
Step 6 Power Up
Replace the computer cover and reconnect the AC power cords. Turn power on to the
host computer. Observe the messages that display during the boot process until you see
the following message:
Press Ctrl-M to run MegaRAID IDE Setup Utility
Step 7 Configure the System BIOS
When the ”Press Ctrl-M” message appears on the screen, press the <Ctrl> key and <M>
key immediately to run the BIOS Configuration Utility. See the
IBM ATA 133 RAID
Controller User’s Guide on the Driver and Documentation CD for information about how
to run and use this program.
Step 8 Install the Operating System Driver
The IBM ATA 133 RAID controller can operate under MS-DOS® or any DOS-
compatible operating system using the standard AT BIOS INT 13h Hard Disk Drive
interface. To operate with other operating systems, you must install software drivers. IBM
provides software drivers on the Driver and Documentation CD for the following
operating systems:
•
Microsoft Windows 2000 Server, Advanced Server, and Professional
•
Microsoft Windows XP Professional
•
Red Hat Linux 7.3
Refer to the IBM ATA 133 RAID Controller User’s Guide on the Driver and
Documentation CD for more information.
Step 9 Run MegaRAID Configuration Console
Use the MegaRAID Configuration Console utility to display and configure the physical
drives, arrays, and logical drives for the system. You can also perform consistency checks
and rebuilds of the drives in the arrays.
See the
MegaRAID Configuration Console User’s Guide for more information about
installing and using the utility.