IBM ATA 133, Руководство пользователя

Страница: 24 / 54

IBM ATA 133 RAID Controller User's Guide 18
Step 5 Connect IDE Cables
Before you install and connect the IDE hard drives, you must verify that each drive is set
to Cable Select (CS) addressing mode. To verify this, see the IDE drive documentation.
Select the appropriate cables from the two types included with the RAID controller:
• For any configuration where more than two drives will be connected to the controller,
select the standard length ATA-100/133 cables with two drive connectors.
•
For 1U rack-mounted servers or in configurations where only two drives will be
connected to the controller, select the extended length ATA-100/133 cables with
single drive connector.
Use the selected ATA-100/133 cables to connect up to two IDE drives (one master and
one slave) to each 40-pin IDE connector on the IBM ATA 133 RAID controller. When
using the extended length cables, only one drive will be connected to each channel.
Connect the IDE cables to the IDE hard drives and the IDE connectors on the RAID
controller. The controller provides two IDE connectors:
J1 is the Secondary IDE channel 40-pin connector.
J3 is the Primary IDE channel 40-pin connector.
Connect Pin 1on the IDE cable to Pin 1 on the IDE connectors on the card (J1 and J3).
40-pin
Connector/
IDE Cable
Pin 1
Primary
J3
Secondary
J1
Pin 1
IDE Channel
IDE Channel
Pin 1