IBM AIX HACMP, Руководство пользователя по оборудованию

Страница: 158 / 240

140
IBM Certification Study Guide AIX HACMP
• Reconnect hdisk0, close the casing, and turn the key to normal mode.
• Power on NodeF then verify that the rootvg logical volumes are no longer
stale (
lsvg -l rootvg
).
6.2.4.2 7135 Disk Failure
Perform the following steps in the event of a disk failure:
• Check, by way of the verification commands, that all the Nodes in the
cluster are up and running.
• Optional: Prune the error log on NodeF (
errclear 0
).
• Monitor cluster logfiles on NodeT if HACMP has been customized to
monitor 7135 disk failures.
• Mark a shared disk failed through smit (
smit raidiant
; RAIDiant Disk
Array Manager -> Change/Show Drive Status -> select the appropriate
hdisk -> select the appropriate physical disk -> F4 to select a Drive
Status of 83 Fail Drive), or if the disk is hot pluggable, remove the disk.
• The amber light on the front of the 7135 comes on, and can also be seen
in SMIT (
smit raidiant
; RAIDiant Disk Array Manager -> List all SCSI
RAID Arrays).
• Verify that all sharedvg file systems and paging spaces are accessible (
df
and
lsps -a
).
• If using RAID5 with Hot Spare, verify that reconstruction has completed to
the Hot Spare, then un-mark or plug the failed disk back in. If using
RAID1, sync the volume group (
syncvg NodeFvg
).
• If using RAID5 without Hot Spare, mark the failed disk Optimal (
smit
raidiant
; RAIDiant Disk Array Manager -> Change/Show Drive Status;
select the appropriate hdisk -> select the appropriate physical disk ->
F4 to select a Drive Status of 84 Replace and Reconstruct Drive).
• Verify that the reconstruction has completed (
smit raidiant
;RAIDiant Disk
Array Manager -> List all SCSI RAID Arrays).
• Verify that all sharedvg file systems and paging spaces are accessible (df
and lsps -a) and that the partitions are not stale (
lsvg -l sharedvg
). Also
verify that the yellow light has turned off on the 7135.
6.2.4.3 Mirrored 7133 Disk Failure
• Check, by way of the verification commands, that all the Nodes in the
cluster are up and running.
• Optional: Prune the error log on NodeF (
errclear 0
).