IBM 8874 - eServer xSeries MXE 460, Руководство по установке

Страница: 30 / 106

9. Remove the protective cover, tape, or label from the surface of the
microprocessor socket, if any is present.
10. Lift the microprocessor-release lever to the fully-open position (approximately
135° angle).
Lever closed
Lever fully
open
11. Touch the static-protective package that contains the new microprocessor to
any unpainted metal surface on the server; then, remove the microprocessor
from the package.
Attention: To avoid bending the pins on the microprocessor, do not use
excessive force when pressing it into the socket.
12. Position the microprocessor over the microprocessor socket as shown in the
following illustration. Carefully press the microprocessor into the socket.
Microprocessor
orientation indicator
Microprocessor-
release lever
Microprocessor
connector
Microprocessor
13. Close the microprocessor-release lever to secure the microprocessor.
14. Remove the heat sink from its package and remove the cover from the bottom
of the heat sink.
15. Position the heat sink above the microprocessor; then, press the heat sink into
place and close the heat-sink release lever.
Note: If you are installing an additional microprocessor in microprocessor
socket 3 or 4, a VRM must also be installed.
16. If necessary, install a VRM in the correct connector.
17. Reinstall the microprocessor tray in the server:
a. Install the air baffle in the microprocessor tray.
b. Place the air baffle on top of the heat sinks and the microprocessor baffles.
c. Make sure that the microprocessor-tray release latch is open; then, push
the microprocessor tray into the server.
d. Close the tray levers and make sure they are securely latched.
18
IBM
ERserver
xSeries 460 Type 8872 and xSeries MXE 460 Type 8874: Installation Guide