IBM 8841 - eServer xSeries 236, Руководство по установке опций

Страница: 20 / 74

Light path diagnostics panel
The following illustration shows the remind button and the LEDs on the light path
diagnostics panel. The light path diagnostics panel is inside the server under the
left-side cover and the error LEDs are also visible through the left-side cover.
CPU VRM S_ERR
MEMORY
DASD/
RAID
NMI SERVICE
PROCESSOR
BUS
FAN
POWER
SUPPLY
PCI
BUS
2
1
CONFIG
TEMP
REMIND
Use the remind button on the light path diagnostic panel to acknowledge that an
error has occurred without taking further action. When you push the remind button,
the system error LED will flash every 2 seconds until the error is fixed. If another
error occurs, the system error LED will then stop flashing and return to a solid on
state.
For more information about light path diagnostics, see the Hardware Maintenance
Manual and Troubleshooting Guide on the IBM xSeries Documentation CD.
The following table lists the light path diagnostics LEDs, the problems that they
indicate, and actions to solve the problems.
LED Problem Action
POWER SUPPLY 1 Lit LED: Power supply 1 has failed. 1. Remove ac power from the server.
2. Replace the power supply; then, reconnect the server
to ac power and restart the server.
Flashing LED: Power supply 1 was
removed in a redundant
power-supply configuration.
Install a new power supply in the PS1 location.
POWER SUPPLY 2 Lit LED: Power supply 2 has failed. 1. Remove ac power from the server.
2. Replace the power supply; then, reconnect the server
to ac power and restart the server.
Flashing LED: Power supply 2 was
removed in a redundant power
supply configuration.
Install a new power supply in the PS2 location.
MEMORY A memory error has occurred. Replace the failing DIMM, indicated by the lit LED on the
system board.
CONFIG See the note following this table. See the note following this table.
8
IBM xSeries 236 Type 8841: Option Installation Guide