IBM 8647 - Eserver xSeries 225, Руководство по техническому обслуживанию и устранению неисправностей

Страница: 73 / 182

6. In the Advanced Configuration and Power Interface (ACPI) PC Properties
window, click the Driver tab; then, click Update Driver .
7. In the Update Device Driver Wizard window, click Next .
8. In the next window, click Display a list of known drivers for this device so
that I can choose a specific driver ; then, click Next .
9. In the next window, click Show all hardware of this device class . From the
Models list, select ACPI Multiprocessor PC ; then, click Next .
10. If the configuration shown in the wizard is satisfactory, click Next to save the
configuration.
11. Click Finish to complete the process.
12. Click Yes to restart the server.
13. Continue with step 1 of “Installing the microprocessor”
Installing the microprocessor
Complete the following steps to install an additional microprocessor:
1. Review “Safety information” on page 131 and “Installation guidelines” on page
37
2. Turn off the server and all attached devices.
3. Disconnect all power cords; then, disconnect all external cables.
4. Remove the side cover (see “Removing the side cover” on page 41).
5. Remove the frame-support bracket (“Removing the frame-support bracket” on
page 43).
6. Remove the adapter airflow guide:
a. Rotate the front and rear adapter-retention brackets to the open (unlocked)
position.
b. Slide the adapter airflow guide out of the guides on the air baffle and front
adapter-support bracket; then, remove it from the chassis.
7. Remove the air baffle by unhooking it from its retaining tabs and lifting it off the
chassis.
8. Locate the second microprocessor socket.
9. Remove the microprocessor baffle from the second microprocessor socket.
10. If the second microprocessor socket is covered with protective film, peel and
remove the film.
Chapter 4. Installing options
63