IBM 847620U - Netfinity 3000 - 20U, Руководство по техническому обслуживанию аппаратной части, Страница: 38 / 270

Attention
Keep a record of the power-on password in a secure
place. When a power-on password has been set, you
cannot activate the keyboard and mouse without first
using the password. If you lose or forget the
password, you cannot change or delete it without
removing the server cover and moving a jumper on
the system board. See “Erasing lost or forgotten
passwords” on page 42 for further information.
To set or change a power-on password:
1. From the Configuration/Setup Utility program menu,
select System Security; then, press Enter.
2. The System Security menu appears.
3. Select Power-On Password; then, press Enter.
4. The Power-On Password menu appears.
5. To set a power-on password, enter the password in
the appropriate data field and press the Down Arrow
(
↓
) key.
You can use any combination of up to seven
characters (A–Z, a–z, and 0–9) for this password.
Keep a record of the password in a safe place.
6. Enter the password again in the appropriate data
field.
7. In the Password Prompt data field, select Off, On,
or Dual. Press the Left Arrow (
←
) or Right Arrow (
→
)
key to toggle among selections.
Note
If Remote Administration is enabled, you
cannot select On. In this case, select Dual. If
the power-on password mode is set to On when
Remote Administration is enabled, it resets
automatically to Dual.
8. To change a power-on password, select Change
Power-On Password from the Power-On Password
menu, and follow the instructions on the screen.
Notes
1. If a power-on password is set and then forgotten,
you must remove the server cover and move the
Clear CMOS Request jumper on the system
board. (See “Erasing lost or forgotten
passwords” on page 42 for further information.)
2. If a power-on password is set and the password
prompt is set to Off, the pointing device (mouse)
is disabled until you enter the power-on
password.
To delete a power-on password:
30
Netfinity Server HMM