IBM 847620U - Netfinity 3000 - 20U, Руководство по техническому обслуживанию аппаратной части, Страница: 136 / 270

Notes
1. When you are removing a memory module, be
careful not to push too hard on the retaining clips
because the memory module might abruptly eject
from the connector.
2. Each memory connector contains two keys
(dividers), which are used to assure that a
memory-module can be installed only in the
correct position.
3. A retaining clip at each end of the connector
locks the memory module into place.
4. For information about memory configuration, see
Table 5.
To install a DIMM:
1. Remove the server side cover (see “Disconnecting
cables and removing the side cover” on page 84).
2. Locate the memory connectors on the system board.
See the illustration at the beginning of this section.
3. Be sure that the retaining clips are in the open
position, as shown in the following right-hand
illustration. If the retaining clips are perpendicular to
the connector, push outward on them until they click
open.
4. Touch the static-protective package containing the
DIMM to any unpainted metal surface in the server;
then, remove the DIMM.
5. Position the DIMM above the connector so that the
two notches on the bottom edge of the DIMM align
properly with the connector.
6. Firmly push the DIMM straight down into the
connector until the retaining clips close and snugly fit
around both ends of the DIMM.
128
Netfinity Server HMM