IBM 8270, Инструкция по установке и обслуживанию

Страница: 55 / 98

Chapter 3. Setting up a Console Session
You can set up a console session locally by directly connecting a PC or other DTE
to the EIA 232 port on the 8270. You also can set up a console session remotely
by connecting a modem to the EIA 232 port and then dialing in from your remote
station. To connect a terminal directly to the 8270, continue with “Connecting a
Local Terminal.” To use a modem, go to “Connecting a Modem to Allow Remote
Terminal Access” on page 3-2.
Connecting a Local Terminal
To connect a local terminal to the 8270, perform the following steps:
Step 1. Begin running your terminal emulation software on the PC or other DTE
to which you will be connecting the 8270.
Step 2. Set the terminal as follows. See "Serial Link Configuration" in Chapter 3
of 8270 Models 600 and 800 Planning, Configuration, and Operation.
Note: Some emulators do not have all of the options listed below.
Step 3. If you are using Microsoft Windows terminal emulation, set the Function,
Arrow, and Ctrl Keys to act as terminal keys instead of Windows keys.
Step 4. Connect the EIA 232 port on the 8270 to your PC or DTE device using a
null-modem cable or straight-through cable and null-modem adapter. The
8270 has a 9-pin, male connector. For pinout and cable information, see
Appendix A, “Cable and Pin Information.”
Baud rate 1200, 2400, 4800, 9600, 19 200,
38 400, 57 600
(9600 is the default)
Parity None
Data bits 8
Stop bits 1
Handshaking None
Terminal emulation VT100
Duplex Full
Software flow control (XON/XOFF) Off
Hardware flow control (RTS/CTS) Off
Line wrap Off
Screen scroll On
CR translation CR
Backspace (BS) translation Destructive
Break length (milliseconds) 350
Enquiry (ENQ) Off
EGA/VGA true underline Off
Terminal width 890
ANSI 7- or 8-bit commands 7

Copyright IBM Corp. 1998
3-1