IBM 71455RU, Инструкция по установке и эксплуатации

Страница: 107 / 136

- Custom mode
Select this choice only if you understand the functions of the low-level IMM
settings. This is the only choice that enables you to change the low-level
IMM settings that affect the performance and power consumption of the
server.
– Integrated Management Module
Select this choice to view or change the settings for the integrated
management module.
- POST Watchdog Timer
Select this choice to view or enable the POST watchdog timer.
- POST Watchdog Timer Value
Select this choice to view or set the POST loader watchdog timer value.
- Reboot System on NMI
Enable or disable restarting the server whenever a nonmaskable interrupt
(NMI) occurs.
Disabled is the default.
- Commands on USB Interface Preference
Enable or disable the Ethernet over USB interface on IMM.
- Network Configuration
Select this choice to view and select the system management network
interface port, the IMM MAC address, the current IMM IP address, and host
name; define the static IMM IP address, subnet mask, and gateway
address; specify whether to use the static IP address or have DHCP assign
the IMM IP address; save the network changes; and reset the IMM.
- Reset IMM to Defaults
Select this choice to view or reset the IMM to the default settings.
- Reset IMM
Select this choice to reset the IMM settings.
– Legacy Support
Select this choice to view or set legacy support.
- Force Legacy Video on Boot
Select this choice to force INT video support, if the operating system does
not support UEFI video output standards.
- Rehook INT
Select this choice to enable or disable devices from taking control of the
boot process. The default is
Disable .
- Legacy Thunk Support
Select this choice to enable or disable UEFI to interact with PCI mass
storage devices that are not UEFI compliant.
- Network
Select this choice to view or configure optional network devices, such as
iSCSI, PXE, and network devices. There might be additional configuration
choices for optional network devices that are compliant with UEFI 2.1 and
later.
v
Date and Time
Select this choice to set the date and time in the server, in 24-hour format
(
hour : minute : second ).
This choice is on the full Setup utility menu only.
v
Start Options
Chapter 3. Configuring the server
89