IBM 7042-CR6, Устранение неполадок, обслуживание и поддержка

Страница: 26 / 64

v
Yes : This ends the procedure.
v
No : Continue with step 3.
3. Check for network problems, cables, switches, link lights on the service processor, and so on.
Was there a problem?
v
Yes : Correct the problem and return to step 2 on page 13.
v
No : Continue with step 4.
4. Reset the service processor to force it to request a new IP address. see “Resetting the service
processor” on page 30.
5. Did resetting the service processor resolve the problem?
v Yes
:
This ends the procedure.
v
No : Contact your next level of support.
6.
If your system uses static IP addressing, add a system manually by performing the following steps:
a. In the Welcome page, select Common tasks > System Discovery .
b.
Enter the IP address of the resource that you need to discover.
c. Select the resource type.
d. Click Discover Now .
Can you locate the system using Find a resource ?
v
Yes : This ends the procedure.
v No : Contact your next level of support.
Powering on and off the Systems Director Management Console and
system
Use one or more of the following procedures to power on or power off your IBM Systems Director
Management Console (SDMC) or system.
Powering on the SDMC
During the process of powering on, the SDMC checks to see which servers are available and
communicating with the console. To ensure that each server is available before you power on the SDMC,
servers must be in standby mode or actively operating. Standby mode is indicated by the
OK
shown in
the operator panel after the server has the power connected and the initial tests are complete.
Note: If the server is in an emergency power off (EPOW) condition, the server must be brought to
standby mode before the SDMC can be used to power on the system.
To power on the SDMC, perform the following steps:
1. Press the Power button once to turn on the power.
2. When the system has finished the power-on self-test (POST), log in to SDMC.
Powering off the SDMC
Attention: If possible, shut down all applications and virtual servers before powering off the system.
Using either the power-on button on the control panel or entering commands at the SDMC to stop the
system can cause unpredictable results in the data files. Also, the next time you start the system, it might
take longer if all applications are not ended before stopping the system.
To power off the SDMC, complete the following steps:
1. In the Welcome page, open Settings .
2. Under Restart or Shut Down tasks , click Shut down or Restart IBM Systems Director Management
Console . The Restart window opens.
14
Troubleshooting, service, and support using SDMC