IBM 6C1, Руководство по установке

Страница: 77 / 144

2
3
2 Drive
3 Drive tray handle (in open
position)
1. If the server is a Model 6E1, unlock and open the server door.
Attention: To maintain proper system cooling, do not operate the server for more
than two minutes without either a drive or a filler panel installed for each bay.
2. Remove the filler panel (1) from one of the empty hot-swap bays by inserting your
finger into the depression at the left side of the filler panel and pulling the panel
away from the server.
Attention: Do not remove the drive from the tray assembly.
3. Install the hard disk drive (2) in the hot-swap bay:
a. Ensure the drive tray handle (3) is open (that is, perpendicular to the drive).
b. Align the drive/tray assembly so that it engages the guide rails in the bay.
c. Gently push the drive/tray assembly into the bay until the drive connects to the
backplane.
d. Push the tray handle to the right until it locks.
4. Check the hard disk drive status indicators to verify that the hard disk drives are
operating properly.
5. Repeat the previous steps for all the drives you are installing.
6. Log in as root user.
Chapter 3. Installing Options in Your System
61