IBM 3409-S03, Инструкция по эксплуатации прибора

Страница: 57 / 82

Chapter 6. Module replacement
Overview
Observe all precautions when replacing modules.
Important: Always have available a replacement or blank module before removing the old module.
When you replace a module, you must never leave an empty bay in the rear of the enclosure.
ESD Precautions
Important: Fit and check a suitable anti-static wrist or ankle strap and observe all conventional ESD
precautions when handling plug-in modules and components. Avoid contact with midplane and
sideplane components, and with module connectors.
Continuous operation during replacement
Your hardware or software enclosure management application determines the capability of replacing a
failed disk without loss of access to any file system on the enclosure. Enclosure access and use during
this period is uninterrupted. If an enclosure contains two PSUs, one of them can maintain power to the
system while the other is replaced.
Field replaceable units (FRUs)
Please refer to the IBM Field Replaceable Units Reference Guide for more information.
The IBM Cloud Object Storage System
™
Slicestor
®
2584 does not feature hot swap sideplanes.
General procedures
General procedures include opening and closing drive drawers.
Opening a drawer
1. Make sure the anti-tamper locks are not engaged. The red arrows on the locks point inwards if the
locks are disengaged (see the following figure). Unlock them if necessary by rotating them
counterclockwise using a screwdriver with a Torx T20 bit.
© Copyright IBM Corp. 2016, 2018
41