IBM 3409-S03, Инструкция по эксплуатации прибора

Страница: 22 / 82

DANGER
Do not remove covers from the enclosure or any of the modules. There is a danger of electric shock
inside. Do not attempt to disassemble the rear subchassis from the enclosure. Return any damaged
components to your supplier for repair.
DANGER:
Hazardous voltage, current, or energy levels are present inside any component that has
this label attached. Do not open any cover or barrier that contains this label. (L001)
CAUTION:
The PSUs contain double pole/neutral fusing. Ensure that your electrical installation can support this
type of fusing.
Rack system safety precautions
The enclosure must be mounted in a rack before use.
The rack must support the total weight of the installed enclosures. A fully populated enclosure weighs up
to 135 kg (298 lb). The design should incorporate stabilizing features suitable to prevent the rack from
tipping or being pushed over during installation or in normal use.
When loading a rack with enclosures, fill the rack from the bottom up. When removing enclosures, empty
from the top down.
CAUTION:
The enclosure must be mounted into a rack by using the supplied rail kit only. Due to its weight and
length, the enclosure must not be flange mounted.
Before mounting the enclosure, remove all DDIC modules from both drawers and make sure that the
drawers are closed firmly and locked shut. Do not try to lift the enclosure by yourself (see "Handling").
CAUTION:
Never move more than one enclosure out of the rack at any one time. There is a danger of the rack
falling over.
The system must be operated with low-pressure rear exhaust installation. The back pressure that is
created by the rack doors and obstacles is not to exceed 5 pascals (0.5 mm water gauge).
The minimum open area for the rack doors is 70%.
The rack design should consider the maximum operating ambient temperature for the enclosure, which is
35°C.
The rack must have a safe electrical distribution system. It must provide overcurrent protection for the
enclosure and must not be overloaded by the total number of enclosures that are installed in the rack.
When addressing these concerns, consideration should be given to the electrical power consumption
rating shown on the nameplate.
6
Slicestor
®
2584 Appliance Manual