3
CAUTION!
Handling Safety - Use safe practices when lifting.
<18 kg (<40 lb)
32–55 kg (70–120 lb)
18–32 kg (40–70 lb)
>55 kg (>120 lb)
>10º
CAUTION! Electrical Safety
Electrical Current from power, telephone, and communication cables is hazardous. Please read the following safety
statements.
•
Do not connect or disconnect any cables or perform installation, maintenance, or reconfiguration of this product during
an electrical storm.
•
Connect all power cords to a properly wired and grounded electrical outlet.
•
Connect to properly wired outlets any equipment that will be attached to this product.
•
When possible, use one hand only to connect or disconnect signal cables.
•
Never turn on any equipment when there is evidence of fire, water, or structural damage.
•
Disconnect the attached power cords, telecommunications systems, networks, and modems before you open the device
covers, unless instructed otherwise in the installation and configuration procedures.
•
Connect and disconnect cables as described in the following table when installing, moving, or opening covers on this
product or attached devices.
To Connect:
To Disconnect:
1.
Turn everything OFF.
2.
First attach all cables to devices.
3.
Attach signal cables to connectors.
4.
Attach power cords to outlet.
5.
Turn device ON.
1.
Turn everything OFF.
2.
First remove power cords from outlet.
3.
Remove signal cables from connectors.
4.
Remove all cables from devices.
•
Do not work alone under hazardous conditions.
•
High current through conductive materials could cause severe burns.
•
Check that the power cord(s), plug(s), and sockets are in good condition.
•
Use qualified service personnel to change the plug on the UPS.
•
When grounding cannot be verified, disconnect the equipment from the utility power outlet before installing or connect-
ing to other equipment. Reconnect the power cord only after all connections are made.
•
Do not handle any metallic connector before the power has been disconnected.
•
Connect the equipment to a three wire utility outlet (two poles plus ground). The receptacle must be connected to appro-
priate branch circuit/mains protection (fuse or circuit breaker). Connection to any other type of receptacle may result in
risk of electrical shock.
•
HV models only:
•
In order to maintain compliance with the EMC directive for products sold in Europe, output cords attached to the
UPS should not exceed 10 meters in length.
