IBM 2858-A10, Инструкции по установке и настройке

Страница: 9 / 28

Installing the rails in an IBM 19-inch rack
Use these instructions to install the rails on which you will mount the N6000 series filer.
Attention: Read these instructions in their entirety before proceeding.
Observe the following rules and restrictions when installing an N series system in a standard IBM 19-inch
(48.26 cm) equipment rack with mounting rails:
DANGER
To avoid hazardous conditions due to uneven mechanical loading, always install the heaviest
devices in the bottom of the rack cabinet. Always install servers and optional devices starting from
the bottom of the rack cabinet. (R001 part 1 of 2)
v
When installing storage expansion units in a rack, do not exceed the maximum storage limit for your
system.
v
Make sure that the ID on the back panel of each storage expansion unit matches the ID specified on its
label.
v
Always install the storage expansion units fully loaded. Do not remove disk drives to reduce the
weight.
1. Loosen (but do not remove) the four rail adjustment screws on each rail. See Figure 2 on page 4.
Model A10/A11/A12
Model A20/A21/A22
(A10/A11/A12)
N6000 series
Expansion Unit 4
Expansion Unit 3
Expansion Unit 2
.
.
.
N6000 series
Node 2, Loop or SAS Stack 1
Node or SAS Stack 2, Loop 1
(A20/A21/A22)
Node or SAS Stack 1, Loop 1
Node 1, Loop 1 or SAS Stack
Expansion Unit 1
Expansion Unit 2
Expansion Unit 1
Expansion Unit 2
.
.
.
.
.
.
n600003
Installation and setup instructions
3