IBM 2-Gigabit Fibre Channel PCI, Инструкция по установке и использованию

Страница: 27 / 52

__ 10. Verify that the device driver is already installed by typing the following at the
system prompt:
dsh "lslpp -l devices.pci.df1000f9* 2>&1" |more
__ 11. If the device driver is already installed on the node, contact your service
provider to have the adapter installed.
OR
If the device driver is not installed on the node, proceed to section “Installing
Device Drivers on the SP Nodes” on page 18.
Installing Software on the Control Workstation
Note: If your system is
partitioned; that is, there are more than one operating system
among the nodes, you may only install this adapter in nodes that have AIX 4.3.3
or later.
__ 1. If you are not logged into the Control Workstation as a root user, log in now. You
may also need to export the working collective. Refer to “Checking System
Prerequisites” on page 9.
__ 2. Select the appropriate CD-ROM for the operating system, as follows:
v
AIX 4.3.x - Additional Device Software
__ 3. Insert the installation media into the drive of the Control Workstation.
__ 4. Transfer the files to the Control Workstation’s lppsource, as follows:
a. Type the following, and then press Enter.
smitty bffcreate
b. Select the input device/directory. Press F4. Then move the cursor to the
appropriate input device and press Enter.
c. Move the cursor to the SOFTWARE package to copy option and press F4
to select the software to be installed. Use the F7 key to select the following
device driver(s) at the system prompt:
devices.pci.df1000f9
Press Enter.
d. Move the cursor down to DIRECTORY for storing software package and
enter the appropriate lppsource destination directory:
/spdata/sys1/install/<lppsource_name>/lppsource
Use the <lppsource_name> you recorded earlier.
e. Press Enter to begin copying the files.
Note: This step may take several minutes while the directory table of
contents is updated.
__ 5. Update the SPOT (Shared Product Object Tree) by doing the following:
a. Type the following at the system prompt:
smitty nim_res_op
Chapter 4. Installing the Device Driver on the RS/6000 SP System
17