IBM 2-Gigabit Fibre Channel PCI, Инструкция по установке и использованию

Страница: 21 / 52

1 eion01.ppd.pok.i 08005A75A6D4 0 disk hdisk0
default Thu_Dec__4_09:07:23 default <lppsource>
<pssp level>
<lppsource>
is the lppsource name for the node.
<pssp level>
is the PSSP
level installed on the node. The required PSSP level is 3.1.1 or later.
If the nodes are not at a supported PSSP level, upgrade the PSSP level on the
nodes. Contact the system administrator for assistance.
__ 7. Record the name that appears below
lppsource_name
for each node on which
the adapters are being installed. You will use this information later.
__ 8. Verify that the device driver is installed in the lppsource directory by typing the
following at the system prompt:
cd spdata/sys1/install/<lppsource_name>/lppsource
<lppsource_name> was recorded in the previous step. Once you are in this
directory, verify that the fileset is in the lppsource directory by typing the
following at the prompt:
ls devices.pci.14100401*
If the device driver is not in the lppsource directory, proceed to section
“Installing Software on the Control Workstation” on page 12 to install the
software.
__ 9. Update the SPOT (Shared Product Object Tree) by doing the following:
__ a. Type the following at the system prompt:
smitty nim_res_op
The Resource Name screen displays with the following highlighted:
boot resources boot
__ b. Move the cursor down until the SPOT resource is highlighted. The SPOT
resource should look similar to:
spot_AIX433 resources spot
The format of the spot name is: spot_<lppsource_name>.
<lppsource_name> was the name you recorded in a previous step.
__ c. When the
SPOT resource is highlighted, press Enter to select this option.
The Network Install Operation to Perform screen displays with the reset
option highlighted for selection.
__ d. Move the cursor until the cust option is highlighted and press Enter to
select this option. The Customize a SPOT screen displays with the
Source of Install Images highlighted for selection.
__ e. Press F4 to display the list of installation images and select the
appropriate lppsource.
__ f. Move the cursor until the appropriate lppsource is displayed. For
example:
Chapter 4. Installing the Device Driver on the RS/6000 SP System
11