2
©Copyright Lotronic 2013
GB - INSTRUCTION MANUAL
Thanks for your purchasing, please read this manual carefully before
operating the system. It gives you general information for your safe and
better operation.
Safety Recommendations
•
Before any installation and repair, please do cut off the power supply.
•
For safety reasons, install the unit firmly to avoid injury and damage.
•
Do not cover the unit.
•
The product should be installed by professional technician.
•
Do not touch the unit with wet hands or pull the power wire forcefully.
•
The system should be kept dry .Please don’t use the system in the
condition of rain, wet or dust. For indoor use only.
•
Do not turn on or off the system frequently, and avoid keeping it working
for a long time.
•
Fixed Installation prevents the system from strong shaking or striking.
•
Prevent objects to get into the system, or there will be malfunction.
•
Leave at least 1m distance between the unit and other objects.
•
Please don’t connect the power supply or turn on the system before
installation.
•
Before switching on power, please make sure the power wire is in good
condition.
•
Where the MAINS plug or an appliance coupler is used as the
disconnect device, the disconnect device shall remain readily operable.
•
When transport the system again, please use the original package to
avoid shaking.
Statement
The user should comply with the instructions and warnings above. Any
damage, which is caused by incorrect operation or not following the manual,
is not covered by the warranty.
Installation guide
•
Be sure that there are no inflammable or explosive objects within 1.5m
distance.
•
Before installation, please make sure the power voltage matches the
system rated voltage.
•
Be sure that the fan and exhaust is not blocked.
Check for the contents in the package refer to the following list:
1. Laser lighting: 1
2. Power cable: 1
3. User’s manual: 1
Technical parameters
Laser diode: DPSS, Red 650nm
Power supply: 220V-240Vac, 50-60Hz
Consumption: 20W
Laser power: Red 200mW
Motor: N1.8 high precision step motor
Control mode: Sound control/AUTO/DMX
Dimensions: 205mm x 130mm x 95mm
Net weight: 1.5KG
Gross weight: 1.8KG
Function Setting
0=OFF 1=ON X=OFF or ON
DIPSWITCH CHART
FUNCTION
#1 #2 #3 #4 #5 #6 #7 #8 #9 #10
0
X
X
X
X
X
X
X
X
1
SOUND ACTIVE
1
X
X
X
X
X
X
X
X
1
AUTO MODE
SET DMX ADDRESS FOR DMX MODE
0
DMX/SLAVE
Installation
1. Firstly, be sure that the using voltage matches with the voltage marked
on the base of the laser lighting.
2. Installation should be made by professional technician. Fix the laser
lighting and adjust the angle of the laser lighting to you need; Install the
laser in such a height that the beam can’t hit the eyes of the audience.
3. Please check whether the fan and the exhaust are blocked;
4. There is a hole for connection. When hang the laser lighting, be sure the
cable can support 10 times of the lighting weight;
5. The laser lighting should be fixed;
6. It is essential to be earthed well for the sake of safety.
DMX512
This laser light is controlled by the standard DMX. Please connect
controlling panel with the lighting as following
