iBell CM35-24, Руководство оператора

Страница: 16 / 21

15
The adjustable stationary vice (7) can be rotated to attain cutting
angles from 45° left to 45° right and moved rearward to allow
greater cutting widths.
The mitre angle can be set in a range from 0° to 45°. Often used
angles are identified on the angle stop with appropriate marking.
The 0° and 45° positions are set at the end stops.
To adjust the angle of cut:

Locate the two hex head bolts (15) behind the vice fence. Using
the supplied spanner, loosen both bolts.

Rotate the vice fence until the desired angle of cut is aligned with
the indicator groove in the machine base.

Check the angle of the vice fence to the abrasive wheel using a
protractor, bevel square, or a similar device.

Using the spanner, securely tighten the two hex head bolts
holding the vice to the machine base.
ADJUSTABLE STATIONARY VICE
CUTTING ANGLE ADJUSTMENT
7
15
WARNING!
To reduce the risk of injury, turn unit off and
disconnect machine from power source before installing and
removing accessories, before adjusting or changing set-ups or when
making repairs. Be sure the trigger switch is in the OFF position.
IBL CM35-24