iBeam TE-360-3D, Руководство по установке

Страница: 3 / 16

REV. 8/6/2018 INSTTE-360-3D
3
INSTALLING THE TE-360-3D
(CONT.)
Camera location
example
From the TE-360-3D interface:
• Connect the
Yellow
RCA jack labeled AV-OUT to the aftermarket radio or stand-alone monitor
providing the camera image. Connect the
Red
wire to the reverse trigger wire from the radio/monitor.
Note 1: If using a radio as a display screen, this wire must be connected to trigger the
radio to display an image.
Note 2: If using a stand-alone monitor as a display screen which has an HDMI input, use
the HDMI output instead for a better image.
With the key in the off position:
then Insert the camera through the hole, but do not clip the camera into the hole just yet.
Route the cable into the door, and then to the location where the TE-360-3D interface will
be installed at. Leave the connector accessible inside the mirror to be able to disconnect the
camera if ever need be.
Note:
A metal “U-shaped” adjustment tool is included with each camera. Make sure not to
accidentally throw this tool away while unpacking the cameras.
Remote control IR receiver:
• Install the IR receiver to a location where the remote control has a clear line of sight, and
also no more than 48-inches away from where the TE-360-3D will be installed at. Route the
cable to the location where the TE-360-3D interface will be installed at.
TE-360-3D interface:
From the cameras:
• Connect together the appropriately colored connectors by lining up the arrows and pushing in.
• From the front camera, connect the
Red
wire to the positive trigger wire from the high beam light.
• From the left-side camera, connect the Red wire to the positive trigger wire from the left-side
turn signal indicator.
• From the right-side camera, connect the Red wire to the positive trigger wire from the right-
side turn signal indicator.
• From the rear camera, connect the Red wire to the positive trigger wire from the reverse light.
From the remote control IR receiver:
• Connect together the appropriately colored Black connectors by lining up the arrows and pushing in.
• Connect the Black wire to chassis ground.
• Connect the
Yellow
wire to battery power.
• Connect the
Red
wire to accessory power.
• Install the interface to a location that is hidden,
yet accessible to the owner of the vehicle. The
USB flash drive and SD card (not provided) will
connect directly into the interface.
• Connect the interface harness into the TE-360-3D.
(Figure A)