iB-WRA150N
150M Wireless-N ADSL2+ Router - User Guide
)
Note:
When you add a WAN Restriction entry, you must configure at least one condition on the
preceding screen except the Filter name. If you leave Protocol blank, it means that the rule is
effective to all protocols, if you leave the Source IP address and/or Destination IP address blank, it
suggests that all Source IP addresses and/or Destination IP addresses are controlled by the rule,
if you leave the Source Port and/or Destination Port blank, it suggests that all Source Ports and/or
Destination Ports are controlled by the rule.
4.8.2 Domain Filtering
This section allows you to configure the filtering rules based on Domain to control the computers in
the LAN to access the specified port.
Figure 4-71
Domain Filtering Global Policy
- The default setting is Allow.
•
Allow
means that all MAC layer frames will be allowed except those matching with any of the
specified rules in the following table.
•
Deny
means that all MAC layer frames will be deny except those matching with any of the
specified rules in the following table.
You can change the policy by clicking the
Change Policy
button to go to the Change Domain
Filtering Global Policy page as shown in Figure 4-72.
Figure 4-72
To add a new entry, follow the steps below:
1. Click
the
Add
button in Figure 4-71 to go to the Add Domain Filter page as shown in Figure
4-73.
2. Enter the start IP address.
3. Enter the end IP address.
4. Enter the desire Domain address.
5. Click
Save/Apply
to save your settings.
66
