5
QS Workmaster Bench Assembly:
Step 1:
Attach beam connector plates to the ends of the bench support beams using the 5/16-18 x .75 HH bolts and
1/4” flat washers supplied as shown. DO NOT TIGHTEN THE HARDWARE.
PLEASE NOTE:
If you are installing MTS posts to your
30” deep benches only…make sure to install the MTS
T-nuts, shown in the
QS
MTS Assembly Instructions
prior to installing and securing the frame support
beams to the work surface.
Step 2:
Place worksurface top side down on smooth flat surface being sure to protect it from damage by foreign
objects. IAC recommends the use of packing type blankets or clean cardboard. Place the support beams on
the worksurface with the open side toward the center of the worksurface and align the slots of the support
beams over the threaded inserts in the worksurface as shown. Thread 1/4-20 x .75
HH bolts and 1/4” flat
washers into the threaded inserts to attach the beams to the worksurface. DO NOT TIGHTEN THE
HARDWARE.