26
Let’s listen to music.
Start copying.
Make sure the HyperHyde’s main lamp is blinking.
Wait as is until the main lamp changes from blinking to
on constantly.
Recording is completed when the file is displayed
in the Removable Disk and the HyperHyde’s main
lamp goes on.
Make sure the HyperHyde’s main lamp is not
blinking, then disconnect the HyperHyde’s
parallel cable.
While pressing on the clips on the left and right sides,
pull the parallel cable out of the connector. Make sure
the main lamp goes off.
When the cable is disconnected, close the connector’s
rubber cover.
Recording to the HyperHyde
Check for the selected song.
Apply pressure to the clip and remove it.
Do this after making sure the
main lamp is not blinking.
Exercise caution if you are
working in a bright place
where it is difficult to tell if the
light is on or not.
